Filter
Top Products
-- -- -- -- -- Hel p Message -- -- -- -- --
Data successfuly transmitted
(Hit any key to continue)
Reference
Section 3-5
7.
When the screen data transmission is completed, the support tool will display
the following screen.
8.
Press any key on the support tool to return to the File Selection screen.
9.
Pressing the “EXIT” touch switch in the Transmit Mode screen of the NT600S
will exit the Transmit Mode and enter the System Menu.
Press the “EXIT” touch switch on the NT600S when the screen data transmission
is completed. Unless this touch switch is pressed, the screen data will not be cor-
rectly registered. If the “EXIT” touch switch is pressed during transmission, the
screen data will not be correctly registered.
If screen data cannot be transmitted from the support tool properly, check whether
communication between the NT600S and support tool (personal computer) is nor-
mal.
To check communication with the support tool, use the “Tool Transmit” function in
the maintenance mode of the NT600S. See “Checking the Communications with
the Support Tool/Host” (page 105).
Precautions to be Observed During the Screen Data Transmission
When any of the following or a system error occurs during the screen data trans-
mission, the transmitted screen data will not be registered correctly to the
NT600S. If an error message is displayed in the System Menu and the Transmit
Mode cannot be selected, the screen data memory needs to be initialized.
The power to the NT600S is interrupted or the NT600S is reset.
The power to the computer on which the support tool is running is interrupted or
the computer is reset.
The cable connecting the NT600S to the computer on which the support tool is
running is disconnected or has a broken wire.
The Cancel touch switch on the NT600S screen is pressed to end the transmis-
sion during screen data transfer.
The ESC key on the support tool is pressed to end the transmission.
When the power to the NT600S is turned ON or reset, the screen data is checked.
However, if any of the above occurs during the screen data transmission, the
screen may disappear and other unexpected problems may occur.
In the case of such problems, set DIP SW2-1 to ON to initialize the memory.
For the memory initialization by using the DIP switch, refer to the “Initialization by
using the DIP switch” (page 74).