Filter
Top Products
Note
Appendix C
Installation on a DIN Rail
Hook the top part ofthe rearof the converter unit ((a) in the figure) onto the topedge of the DIN rail, and push the unit
in direction (b).
Then fit end plates on the right and left sides of the converter unit so that the unit cannot shift sideways.
(a)
(b)
Removal from the DIN Rail
Remove the end plates at right and left, then insert a flat-tipped screwdriver into the rail stopper on the bottom of the
unit and pry the unit away.
Installation in an Operation Panel
Make two screw holes in an operation panel wall at least 2 mm thickand securethe converter to the wallwith screws.
100 (3.94)
110 (4.33)
30
(1.18)
21
(0.83)
2-M4
(Unit: mm)
In order to ensure a strong installation, the wall of the operation panel must be at
least 2 mm thick.