Filter
Top Products
Section 2-4
[Making the PC system settings]
The possible settings and existing settings which can be setby the PC system set-
ting are as given below.
Item Possible Setting Existing Setting
Baud rate 2400/4800/9600/19200 bps 9600 bps
Stop bit 1 or 2 stop bits 2stopbits
Parity Even/odd/non-parity Even parity
Data length ASCII 7 bits ASCII 7 bits
Unit # 00 to 31 Unit #00
C-series C200HS, C200HX/HG/HE, CPM1, CQM1
Set the operating conditions to the PC system setting area when a C200HS or
CQM1 CPU is connected to the NT600S. The PC system setting area (data
memory) can be directly accessed from the peripheral tool (LSS etc.).
The following describes the switch settings so as to enable the PC system set-
tings. For thedetails ofthe operation with the PC system setting area, refer to the
“SYSMAC CQM1 Reference Manual” (W228-E1- ).
[Switch settings] (C200HS, C200HX/HG/HE, CQM1)
RS-232C port communication
condition settings
Set DIP switch 5 to OFF (right side)
to enable the PC system settings.
CPU unit DIP switch settings
[Switch settings] (CPM1)
Set the mode setting switch to
the “HOST” (upper) position.
CPM1
CPM1
-CIF01
[PC system setting area settings]
Write settings to the PC system setting area (data memory) according to the port
used to connect to the NT600S.
Channel # Writing Value Settings
DM6645 0001 Host link mode and conditions are set.
D
M
6
6
4
6
0303
Data length: 7 bits, 2 stop bits, even parity,
baud rate: 9600 bps
DM6646
0304
Data length: 7 bits, 2 stop bits, even parity,
baud rate: 19200 bps
DM6648 0000 Unit No. 0