Filter
Top Products
Reference
Section 3-8
To set and quit the menu, press the [SAVE EXIT] touch switch. To quit without
setting, press [EXIT].
ON: The key press sound will be given for 0.2 second when a touch switch is
pressed.
OFF: The key press sound will not be given when a touch key is pressed.
4-8-2 Using the Buzzer
The NT600S can set a buzzer to indicate the occurrence of an emergency or an
NT600S error.
Setting the Buzzer Except when the buzzer has been set so as not to sound at all, the buzzer will
sound when an error occurs. The buzzer can be made to sound in other cases by
using the two following methods.
Sounding under control of the host (when using RS-232C communication)
It is possible to control the NT600S from the host to sound the buzzer during
operation.
See “7-2 Commands Sent by the Host” (page 207).
Set buzzer sounding as a screen data attribute with the support tool
When creating the screen data by using the support tool, set buzzer soundingas
a screen attribute so that the buzzer will sound. When a screen for which this
attribute has been set is displayed, the NT600S buzzer sounds.
If the control by the host and the display of the screen in which the buzzer attribute
has been set areexecuted simultaneously, the priority is given to thecontrol bythe
host. Refer to the NT-series Support Tool Operation Manual (V028-E1- ).
To Stop the Buzzer Sound The buzzer sound can be stopped by the following operation.
Control by the Host
Switch the screen to a screen which does not have a buzzer attribute.
Press the touch switch to which the buzzer stop attribute has been set.
If a buzzer stop attribute has been set to a touch switch created on the screen in
which the buzzer attribute hasbeen set, such touch switch canbe used to stop the
buzzer sound. For details on setting buzzer stop attributes to touch switches, refer
to “Allocating of system key functions” (page 142).