Filter
Top Products
Reference
Reference
Section 6-4
Specifying the Inverse Display
Use the following command to set the inverse display mode.
Set Inverse Display
Format
1B
[ESC]
22
”
Description Sets the display attribute to inverse so that all characters and marks sent subse-
quently are highlighted. Other attributes remain unchanged.
The Set Inverse Display Command is cancelled by the End Inverse Display
Command or the Normal Display Command.
The setting with this command remains valid until the screen display is switched
or another display attribute setting is made. The default display attributes are
set to a normal display when a screen is initially displayed.
Use this command with the Set Flashing Display Command (refer
7-4-2 Set
Flashing Display
) to produce a flashing inverse display.
Canceling the Inverse Display
Use the following command to cancel the inverse display mode.
End Inverse Display
Format
1B
[ESC]
23
#
Description Clears the inverse display attribute so that all characters and marks sent subse-
quently are not highlighted. Other attributes remain unchanged.
The inverse display attribute is set with the Set Inverse Display Command.
The setting with this command remains valid until the screen display is switched
or another display attribute setting is made. The default display attributes are
set to a normal display when a screen is initially displayed.
Specifying the Flash Display
Use the following command to set the flash display mode.
Set Flashing Display
Format
1B
[ESC]
24
$
Description Sets the display attribute to flashing so that all characters and marks sent subse-
quently are displayed flashing. Other attributes remain unchanged.