Filter
Top Products
Comm. Met hod
Key Press Sound
Buzzer Sound
Host Link
OFF
Putting-Out Time
Resume Function
OFF
None
ON
[ MEMORY SWITCH MENU (1/2) ]
Support Tool Mode NT600S
EXIT
SAVE
EXIT
NEXT
PAGE
[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance Mode
[ MAINTENANCE MENU ]
Quit
PT Setting Status
I/O Check
Display History
Memory I ni t.
Memory Swi tches
Section 3-6
Each time the “Comm. Method”
touch switch is pressed, the set-
ting option changes to the next
item in the sequence “Host
Link”, “NT Link”, “NT Link 1:N”,
“RS-232C”.
When a C200H interface unit is
connected, the setting is fixed
as “C200H”.
To set and quit the menu, press the [SAVE EXIT] touch switch. Toquit without set-
ting, press [EXIT].
4-6-2 Baud Rate Selection (Host Link Only)
When using the host link, the baud rate for the communication method must be
set. “9600 bps” or “19200 bps” can be selected.
The factory setting has been made at 9600 bps.
Select thebaud rate ofthe communication with thePC by the menu operation from
the System Menu shown below.
Select “Maintenance Mode”.
Select “Memory Switches”.