Filter
Top Products
Reference
Appendix G
APPENDIX G
Function Restrictions Depending on the Support Tool
When using the direct connection function, screens can be created by using the conventional support tools indi-
cated below.
NT series NT20M/NT2000M/NT600M support tool (Ver.4. )
In addition, the NT series support tool (Ver.2. ) can be used with Ver.4 of the direct connection function.
However, when the above support tools are used or Ver.4 direct connection is used, restrictions apply to some func-
tions, as shown in the table below.
The expressions used for support tools in the table have the following meanings.
NTM V4 : NT series NT20M/NT2000M/NT600M support (Ver.4. )
NT V2 : NT series support tool (Ver.2. )
Support
Tool
NT Model
Direct
Connection
Communication Mode
Support Tool Mode
(NT600S memory
switch)
Restrictions
NTM V4 NT600M OMRON --(Standard) NT600M
Thumbwheel numeral settings
not possible, no upper/lower
l
i
m
i
t
s
h
e
x
a
d
e
c
i
m
a
l
i
n
p
u
t
n
o
t
NT600M Ver. 4 Standard NT600M
l
i
m
i
ts,
h
exa
d
ec
i
ma
l
i
nput not
possible, indirect specification
not possible, touch switch input
t
i
f
i
t
i
f
i
d
“
t
”
NT V2
NT600S Ver. 4 Standard/High-speed NT600S
notification fixed as “momentary”,
data transmission in screen units
not possible.
NT600S Ver. 5 Standard/High-speed NT600S No restriction
The NT600S cannot be used with combinations of support tools and settings other than those indicated above.
When using RS-232C communications, the NT series support tool (Ver.2. ).
However, the NT series NT20M/NT200M/NT600M support tool (Ver.4. ) cannot
be used.
The necessary support tool and “Tool Mode” (NT600S memory switch) settings in
this case are as follows:
PT model : NT600S
Direct setting : No
Communication mode : Standard/High-speed
Tool Mode : NT600S