Note
Communications
port 1
Communications
port 2
I/O port
selector
switch
RS-232C
↔
RS-422A
(RS-232C/
RS-422A)
(RS-232C)
Section 2-4
Connecting to a PC with a 9-pin Connector
Use a connector cable with a9-pin connector on both ends to connect the NT600S
to a PC with a 9-pin connector.
Host I/F connector
(RS-232C 9-pin type)
SYSMAC C series
PC, CVM1/CV
series PC
Host link unit/CPU unit
9-pin connector
RS-232C connector cable
9-pin connector
NT600S
The connector cablewiring for the C series CPU unit (C H) is different from that
for the other PCs. For details, refer to Appendix E Method for Making the Cable for
Connection to the PC/Host (page 264).
Connecting the NT600S to a CVM1/CV Series Host Link Unit
Two types of connectors areprovided to CV500-LK201 host link unit. Both ofthese
connector types can connect to the NT600S with an RS-232C connector cable.
Select the connector cable which matches the connector type.
To connect to communication port 1
This is a 25-pin RS-232C connector. Use a connector cable with a 25-pin con-
nector on one end and a 9-pin connector on the other end (NT600S side).
To connect to communication port 2
This is a 9-pin RS-232C/RS-422A connector. Use a connector cablewith a9-pin
connector on both ends.
Set the I/O port selector switch to the RS-232C side (upper side) to use this port.
Connecting the NT600S to a C Series CQM1 Unit
CQM1 can connect to the NT600S by the RS-232C method. Use an RS-232C
9-pin type connector cable.
To connect to the RS-232C port
This is a 9-pin RS-232C connector. Use a connector cable with a 9-pin connector
on both ends.
Connecting to C Series C200HX/HG/HE
When using C series C200HX/HG/HE models, the NT600S can be connected to
the standard port of the CPU unit, orto ports A and B of the expansion communica-
tion board. Procure an RS-232C type connection cable for the connection. For
details on the specifications, installation method, etc., of the communication board
used for the connection, refer to the “SYSMAC C200HX/HG/HE Installation
Guide” (W302-E1- ).