Filter
Top Products
Section 1-6
2-6 Communications by RS-232C
Control of the NT600S bya Host is executed bytwo kinds of commands supported
by the RS-232C interface which is built into the NT600S.
Operation commands
Operation commands are used to control the display and status of the running
NT600S as well as to notify information.
Screen display, data writing, data inquiries, etc.
Notification of the NT600S operation contents to the Host.
Terminal commands
Terminal commands are used to use the NT600S as a display terminal of the Host.
When the NT600S is used as a display terminal, it can display characters and fig-
ures in accordance with instructions given by the Host, independently of the
screens registered to the NT600S.
These commands are also used if unexpected problems occur.