Filter
Top Products
Note
Section 4-1
To create the NT600S screen data, make settings in the “Tool Settings” screen as
follows.
PT Type :NT600S
Memory Size :128 KB
Direct Access :When using Host link/NT link/C200H direct communication:
Ver.4 or Ver.5.
When using RS-232C: “None”
Direct Macn Type:OMRON
5-1-2 Creating Screen Data
Screen Data Creation Method The screen data is created by using the support tool. The support tool registers the
screen data used with one NT600S to one file.
Screen data can be created by one of the following three methods:
creating a new file;
editing an existing file;
reading and editing selected screens from an existing file.
Screen Data Creation Procedure
The following gives the basic screen data creation procedure. Required settings
and reference pages are given for each step of the procedure.
➡ Select “Tool Settings” in the Main Menu to display the “Tool Settings” screen.
Settings of PT type, memory size, direct connection are made in this screen.
Refer to “Setting the support tool for use with the NT600S” on the previous
page.