Filter
Top Products
Note
Appendix H
APPENDIX H
Making the Cable for Connection to the Support Tool
Make the connection cable for connection to the support tool by referring to the following explanation.
Parts Required
The table below indicates the recommended parts for making the connection cable.
Name Model Remarks
Connector XM2A-2501 25-pin, manufactured by OMRON
XM2A-0901 9-pin (Plug), manufactured by OMRON
XM2D-0901 9-pin (Socket), manufactured by OMRON
Connector cover XM2S-2511 25-pin, manufactured by OMRON
XM2S-0901 9-pin, manufactured by OMRON
Cable AWG28 5P
IFVV-SB
Multicore cable, manufactured by Fujikura, Ltd
CO-MA-VV-SB
5P 28AWG
Multicore cable, manufactured by Hitachi Cable, Ltd
The recommended parts listed above are those applicable when the personal computer features a 25-pin DSub
female connector. If the personal computer features another type of connector, prepare the appropriate parts by
referring to its manual.
Wiring Connections
The connector at the NT600S used for connecting the support tool is also used as the connector for connecting the
PC/Host.
For the pin configuration, refer to NT600S Connector Specifications (page 267).
The wiring connection is shown below.
With a 25-pin Connector
1
2
3
4
5
6
7
8
9
Pin
number
Abbrevi-
ation
FG
SD
RD
RS
CS
+5V
--
--
SG
RS-232C
interface
RS-232C
interface
Pin
number
Abbrevi-
ation
1
2
3
4
5
6
7
8
--
FG
SD
RD
RS
CS
--
SG
--
--
Shielding
wire
NT600S PC (RS-232C 25pin connector)
--
--
--
ER
--
--
--
20
For some host computers the combination of pin numbers and signal names may
differ from those shown in the diagram above. Refer to the Host instruction manu-
al before wiring the connector.