Filter
Top Products
Caution
Section 4-2
It is also possible to transmit thedata in screen units by pressing [F10] (Next), then
[F6] (Transmit) on the “Screen List” screen. However, the memory table data and
direct information are not transferred when this function is used. Use the transmis-
sion screen to change and add this information and transmit it with the other in-
formation.
For the connection procedure to the support tool, refer to Section 2-3 Connecting
to the Support Tool (page 30). For the transmission of the screen data, refer to
Section 3-5 Registering the Screen Data (page 79).
When transferring the data in units of screens, if there are changes in memory
table and/or direct connection, transfer such data along with the screen data.
Otherwise the system may operate unpredictably.
5-2 Outline of Functions
5-2-1 NT600S Screen
This section gives the outline of the screen which is the basis of all NT600S func-
tions.
For specific operation procedure using Host/NT link or C200H direct such as
screen switching, refer to Section 4-3 Screen Display” (page 124).
For actual operations such as displaying the specified screen using RS-232C, re-
fer to Section 6-2 Commands Sent by the Host (page 207).
Composition of the Screen The NT600S screen is composed of horizontal 640 dots x vertical 400 dots. Each
dot is set by the combination of the X (horizontal) and Y (vertical) coordinates. The
origin of coordinates (0, 0) is set at the top left corner of the screen.
X coordinate (horizontal)
Y coordinate
(vertical)
Coordinates
(x, y)
639
639, 399
399
0
0
Screen Management The screens displayed on the NT600S are managed by the screen numbers.
Screen numbers are set when the screen data are created by using the support
tool. Up to 1000 screens can be set by allocating arbitrarily selected numbers 1 to
1000.
The display screens can be switched orthe start-up screen can beset bydesignat-
ing the screen number from the PC/Host.
Special Screen Number Screen number “0” is reserved for the system as the no-displayscreen. Select this
to display nothing on the NT600S screen