Filter
Top Products
Reference
[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance Mode
[ MAINTENANCE MENU ]
Quit
PT Setting Status
I/O Check
Display History
Memory I ni t.
Memory Swi tches
Section 3-8
4-8-4 Resume Function (Featured with Battery Unit Only)
The resume function is used to maintain the data contents of numeral/character-
string memory tables when the power is switched off or the reset switch is pressed.
If the resume function is set “ON”, the memory table is not initialized even whenthe
power is switched off, thereset switch is pressed, or the mode is changed from the
system menu to the transmit mode.
It is possible to redisplay the screen contents displayed before switching off the
power when restarting the operation next using the values stored to the memory
table before the switching off of the power.
The memory table is always initialized disregarding of the ON or OFF setting of the
resume function if the memory table is initialized using the “Memory Init.” of the
MAINTENANCE MENU. For the procedure for initializing the memory table, refer
to Initialization of the Memory Tables (page 75).
The resume function can be used only when an optional battery unit is installed.
However, if the battery voltage is low, the contents of the memory table cannot be
retained even when the resume function is set “ON”.
Whether or not the resume function is used is set by the Memory Switch.
The factory setting for the resume function is “OFF”.
Select the setting for the resume function by the menu operation from the System
Menu shown below.
Select “Maintenance Mode”.
Select “Memory Switches”.