Filter
Top Products
234
CX-Programmer Section 8-1
8-1 CX-Programmer
Connect the CX-Programmer Support Software to the Coordinator Module to
create and monitor programs for all Modules. While monitoring the ladder pro-
grams in Motion Control Modules, it is possible to input operation conditions
for monitoring the I/O of the Coordinator Module, and to debug programs.
The FQM1 Patch Software is required to create the FQM1 ladder program,
make System Setup settings, and monitor or debug operation.
The FQM1 Patch Software must be installed for the CX-Programmer Ver. 5.0
(Model: WS02-CXPC1-E-V50). It cannot be installed for the CX-Programmer
Ver. 4.0 or earlier. To connect the FQM1 and a personal computer, use the
cables shown in the following table.
Note These RS-232C Connecting Cables cannot be used to connect to the CX-
Programmer with Peripheral Bus communications. Connect to the CX-Pro-
gramer with Host Link (SYSMAC WAY) communications.
!Caution Never connect a PLC Programming Console (such as the C200H-PRO27) to
the Coordinator Module’s peripheral port. The FQM1 may malfunction if a
PLC Programming Console is connected.
Name Model Specifications
Programming Device
Connecting Cables
(for peripheral port)
CS1W-CN118 Connects a personal computer (Microsoft Windows OS).
D-Sub 9-pin receptacle (converts between RS-232C and peripheral com-
munications)
(Length: 0.1 m)
CS1W-CN226 Connects a personal computer (Microsoft Windows OS).
D-Sub 9-pin (Length: 2.0 m)
CS1W-CN626 Connects a personal computer (Microsoft Windows OS).
D-Sub 9-pin (Length: 6.0 m)
Programming Device
Connecting Cables
(for RS-232C port)
XW2Z-200S-CV Connects a personal computer (Microsoft Windows OS).
D-Sub 9-pin (Length: 2.0 m), Static-resistant connector used.
XW2Z-500S-CV Connects a personal computer (Microsoft Windows OS).
D-Sub 9-pin (Length: 5.0 m), Static-resistant connector used.
XW2Z-200S-V Connects a personal computer (Microsoft Windows OS).
D-Sub 9-pin (Length: 2.0 m) (see note)
XW2Z-500S-V Connects a personal computer (Microsoft Windows OS).
D-Sub 9-pin (Length: 5.0 m) (see note)
USB-Serial Conver-
sion Cable
CS1W-CIF31 USB to D-Sub 9-pin conversion cable
(Length: 0.5 m)