Filter
Top Products
220
Analog Input Functions Section 7-9
A562 00 Analog Out-
put 1 Flags
User Adjustment
Completed
Initial value is 0.
Set to 1 if user performs offset/gain adjustment and
Returns to factory default setting of 0 if adjustment
value is cleared.
Motion
Control
Module
01 to 03 Reserved ---
04 Operating ON: ON while the analog output is being changed
by ACC(888).
OFF: Turned OFF when target value is reached.
Motion
Control
Module
05 to 07 Reserved ---
08 Output SV Error ON: ON when the output SV setting is outside of
the allowed setting range.
OFF: OFF when the output SV is within range.
Note Only in End refresh mode
Motion
Control
Module
09 to 11 Reserved ---
12 Factory Adjust-
ment Value Error
ON: ON when the factory-set data stored in flash
memory is invalid.
OFF: OFF when the factory-set data stored in
flash memory is normal.
Motion
Control
Module
13 Reserved ---
14 User Adjustment
Value Error
ON: ON when the user-set adjustment value
stored in flash memory is invalid.
OFF: OFF when the user-set adjustment value
stored in flash memory is normal.
Motion
Control
Module
15 Reserved ---
A563 00 Analog Out-
put 2 Flags
User Adjustment
Completed
These flags have the same functions as the Analog
Output 1 Flags, above.
Motion
Control
Module
01 to 03 Reserved
04 Operating
05 to 07 Reserved
08 Output SV Error
09 to 11 Reserved
12 Factory Adjust-
ment Value Error
13 Reserved
14 User Adjustment
Value Error
15 Reserved
Word Bits Function Settings Controlled
by