Filter
Top Products
8. Getting started
7. Select the correct AutoAlignment Head location from the Head Location drop down list.
Image 8-92
Head Location: Default
Note: If different AutoAlignment Head location is selected, then you will be prompted again to physically position the AutoAlign-
ment Head at the location as indicated in the drop do wn list.
8. Use the Gimbal control arrows to move the Gimbal until the Camera Live view shows the position as it is desired.
Image 8-93
Gimbal control arrows
Note: Use the S tep size buttons to increase or decrease the adjustment steps of the Gimbal.
Note: Press the R button to control the Gimbal movem ents using the navigation buttons on the eRACU hand held unit.
9. From the Select Projectors that makeup this P osition section, select a projector on whose projected image one ore more HUD
image corners are appea
ring that to be included in the defined position.
R59770509 AUTOALIGNMENT HEAD GEN II 26/11/2013
87