Filter
Top Products
7. Installation
Image 7-6
preparation: making a loop
2. Fix this loop using ferrite as indicated in the picture below.
Image 7-7
preparation: fixing the loop
3. Repeat steps 2 and 3 at the other end of this cable.
Image 7-8
preparation: fixing the loop at the other end of the cable
4. Put one end of the cable in. the middle of warning label as indicated in the picture below.
Note: This warning label is an adhesive PVC film.
Image 7-9
preparation: placing the cable on the warning label
5. Fold this warning label so that the cable is stuck in between this label.
Image 7-10
preparation: fixing the warning label
6. Repeat steps 4 and 5 at the other end of this cable.
Image 7-11
preparation: fixing the warning label at the other end of the cable
7.2.2 Power connections
How to connect the power to the MCU?
1. Connect the supplied power cable to connect the MCU to the power outlet.
2. Plug the female power connector into the male connector at the rear of the MCU.
TOP
Image 7-12
Connectors: mains power (MCU)
How to connect the power to the AutoAlignment Head?
1. Connect the supplied power cable to connect the AutoAlignment Head to the power outlet.
2. Plug the female power connector into the male connector at the rear of the AutoAlignment Head.
38
R59770509 AUTOALIGNMENT HEAD GEN II 26/11/2013