Filter
Top Products
7. Installation
WARNING: M ake sure that the AutoAlignment Head is instantly secured when it is mounted in ceiling mode
(i.e. hanging upside down). Improper fixation may cause perso nal in jury or device damage.
Necessary tools
Open ended nut spanner 10 mm
How to mount the AutoAlignment Head on a mechanical support?
1. Disconnect the power cable and the SFTP Cat.5e cable from the AutoAlignment Head.
2. Loosen and remove the M6 mounting nuts (3x) and washers (3x) from the M6 mounting studs on the AutoAlignment Head.
A
Image 7-2
A M6 nuts and washers (3x)
3. Align the location pin of the AutoAlignment Head to the positioning hole on the mechanical support and slide it in.
A
B
Image 7-3
A AutoAlignment Head
B Mounting plate
4. Orient the AutoAlignment Head until its M6 mounting studs are aligned with their respective fixation holes in the support.
36
R59770509 AUTOALIGNMENT HEAD GEN II 26/11/2013