8. Getting started
Image 8-28
Saving the Acuras 1–point
If a different AutoAlignment Head location is selected, then you will be prompted to physically position the AutoAlignment Head
at the location as indicated in the Alert dialog.
Image 8-29
Alert dialog
10.In the appearing Status information dialog, press the OK button to save the new Acuras 1-point position or the modified selected
position.
Image 8-30
Saving a new Acuras position
The Gimbal orientation (pan and tilt) is saved along with the selected projector, spectrometer, laser and the selected head loca-
tion.
8.6.2.2 Defining Acuras Multi-point
Overview
• Description of the Acuras Multi-point
•Defining the Panel Markers
•Defining the Gimbal positions
Acuras M ulti-point p osition is not available for S IM 5W p rojector.
8.6.2.2.1 Description of the Acuras Multi-point
Introduction
The positions defined in Acuras Multi-point are used to perform white uniformity correction on a projector. Those positions must be
defined in such a way that they a
re well-distributed over the visible part of the projected image of the concerning channel.
R59770509 AUTOALIGNMENT HEAD GEN II 26/11/2013
61
