Filter
Top Products
8. Getting started
Image 8-104
Creating a new position
Note: Selecting an existing position will highlight the s elected projector(s) use d in t his position a nd causes the G im bal to move
to the stored orientation for that position.
Note: Press Delete to delete a n ex isting position, if required. A ll AutoGeometry data belonging to this position will be deleted.
9. Select the AutoAlignment Head ”Default” location from the Head Location drop down list.
Image 8-105
Selecting the AutoAlignment Head location “Default”
Note: By the time of the release of this m anual, only one AutoAlignment Head (i.e. D efault) location head location is allowed
for all positions to be define d for a single AutoGeom etry warp position.
10.Use the Gimbal control arrows to move the Gimbal until the Camera Live view shows the Position as it is desired.
R59770509 AUTOALIGNMENT HEAD GEN II 26/11/2013
93