Filter
Top Products
8. Getting started
Image 8-21
Creating a new position
Note: Selecting an existing p osition will highlight the selected projector us ed in this position.
Note: Use the Delete button to delete an ex isting position, if required. All capture data belonging to this position will be deleted.
Note: If you select an ex isting position an d press the Test button, this position is shown as a s quare on the image and the laser
is sw itched ON and points at the position as it has been defin ed before.
4. Select the correct AutoAlignment Head location from the Head Location drop down list.
Image 8-22
Selecting the correct Head Location
5. From the Select Projectors that make up this Position section, select the projector for which the Acuras1-point position has to be
defined.
58
R59770509 AUTOALIGNMENT HEAD GEN II 26/11/2013