Filter
Top Products
8. Getting started
Introduction
In case of AutoGeometry position subtype: Head-Up Display (HUD), the four corners of the region of interest of the HUD image
need to be measured. These corners can appear on one single channel or on multiple channels. This requires the user to identify
the corners of the HUD in relation to the background channels on which they are projected.
1
2
ab
cd
Image 8-90
Example: HUD corners in multiple channel setup
1 channel 1
2 channel 2
a, b, c, d HUD corners
How to define the AutoGeometry position for HUD image?
1. Project any image or pattern from the projectors for the desired AutoGeometry position subtype: HUD
Note: The projectors include the HUD projector and projectors on whose projected image the HUD image corners are appear-
ing.
2. On the Positioning Page, navigate to Position > Position type and select AutoGeometry from the drop down list. See image 8-74
3. From the Select Camera , Spe ctrometer and Laser subsection select Camera from the drop down lists. See image 8-75
4. Press the Start live view button to see live view of the projected image from the selected camera. See image 8-76
Note: Auto Exposure might take som e seconds to complete, wait until it is comp leted.
5. Press the New buttontodefine a new position or select an existing position from Position drop down list to change it. For a new
position, a name must be entered in the Position edit box. See image 8-77
You will be prompted to physically position the AutoAlignment Head at the correct location. See image 8-87
Note: Selecting an existing position will highlight the s elected projector(s) use d in t his position a nd causes the G im bal to move
to the stored orientation for that position.
Note: Use the Delete button to delete an existing position, if required. All Auto Geome try data belonging to this position will be
deleted.
6. Select HUD from the Position subtype drop down list.
Image 8-91
Position subtype: HUD
86 R59770509 AUTOALIGNMENT HEAD GEN II 26/11/2013