7. Installation
7. INSTALLATION
About this chapter
This chapter describes the full installation flow which is a one time operation only: mechanical installation, connectivity, upload of
the correct calibration files for the spectrometer and settings on the Camera.
The AutoAlignment Head can be fixed using the M6 mounting studs, washers and nuts at its bottom. It can be used in table mount
or ceiling mount mode.
CAUTION: The AutoAlignment Head standard version has not been designed to be used on a motion base
platfo rm.
Overview
• Mechanical installation
• Hardware connections
• Driver installation
• Uploading the calibration files
• Importing the license file
• Camera settings
• AutoAlignment parameters
7.1 Mechanical installation
CAUTION: Hold the un it at the b ottom box to lift and move it. Never hold the cam era or Gimbal to lift the
AutoAlignment Head.
Image 7-1
Lifting instructions: AutoAlignment Head (standard and rugged) version
CAUTION: Disconnect the mains power supply during the AutoAlignment Head installation. Doing not so
may cause electric shock.
The mechanical support must be solid enough t
o sustain the weight of the AutoAlignment Head and t hat it
is in a good and safe location and position. It should have a positioning hole and three fixation holes. See
"Dimensions", page 25.
WARNING: The AutoA lignmen t Head must be instantly and correctly fixated to its mechanical support during
installation.
R59770509 AUTOALIGNMENT HEAD GEN II 26/11/2013 35
