Filter
Top Products
10. Operating Acuras
CAUTION: Acuras Realignment requires a spurious light free system. Before performing it, all light on the
screen other than the projector light must be eliminated.
The best practice is to always run the Acuras realignment on all projectors in the selected group in o rder to
achieve a good result.
By d efault, the patterns on which the autom atic brightness and color measu remen ts are perform ed are gen-
erated in the projectors.
How to start the Acuras Realignment process?
1. Select a projector.
2. Navigate to the Light O utput page and activate the required Golden Alignment set.
Image 10-26
Activating a golden alignment set
Note: Acuras realignment can only be e xecuted when a Golden Alignment for w hich Acuras capture h as been executed is
activated. The active Golden Alignment is indicated at the top of the Acuras page.
3. Navigate to the A curas page, and make either of the selections:
- If you wish to calibrate more than one projector, select the desired projectors or select all projectors in that group.
Image 10-27
Selecting the desired projector(s)
- select group, if you wish to calibrate all projectors of this group.
Image 10-28
Group selected
4. Navigate to Realignment section and select the desired realignment settings. For reference see image 10-22, image 10-23,
image 10-24, image 10-25.
126
R59770509 AUTOALIGNMENT HEAD GEN II 26/11/2013