Filter
Top Products
8. Getting started
Image 8-48
Transferring control to navigation buttons on the eRACU hand held unit
11.Use the Gimbal control arrows to move the selected Panel Marker to its correct position.
Image 8-49
Gimbal control arrows
Note: Use the S tep size buttons to increase or decrease the adjustment steps of the Gimbal.
12.Press the button Move P osition again to automatically store the actual Panel Marker position.
Image 8-50
Panel Marker Center: defined
13.Repeat steps 8 to 12 for the other Panel Markers whose position need to be corrected.
How to define the optional Panel Ma rkers?
By default, the position of Panel Markers 1– 3 and 2–4 is automatically calculated (and valid), but can be changed. This is indicated
by a blue check mark in the P o sition subtype drop down list. This procedure applies to the pentagonal or hexagonal image.
1. If desired, focus on Panel Marker 1–3.
2. Press the button M ove Position to activate the Panel Marker 1–3.
3. Use the left and right Gimbal control arrows to move the Panel Marker to the edge of the visible image.
Visible image area
Image 8-51
Panel Marker 1–3: default position
Visible image area
Image 8-52
Panel Marker 1–3: moved to its new position
70 R59770509 AUTOALIGNMENT HEAD GEN II 26/11/2013