Filter
Top Products
SONICWALL SONICOS STANDARD 3.0 ADMINISTRATOR’S GUIDE
79
Configuring WLAN Properties (TZ 50 Wireless/TZ 150 Wireless/TZ 170 Wireless)
Configuring WLAN Properties
(TZ 50 Wireless/TZ 150 Wireless/TZ 170
Wireless)
The SonicWALL TZ 50 Wireless/TZ 150 Wireless/TZ 170 Wireless includes the WLAN interface in
the Interfaces table on the Network>Settings page.
Clicking the Edit icon for the WLAN interface displays the WLAN Settings window for configuring the
WLAN properties.
•The Enable WLAN setting is checked by default to activate the WLAN interface on the
SonicWALL security appliance.
•Select WiFiSec Enforcement to require that all traffic that enters into the WLAN interface be
either IPSec traffic, WPA traffic, or both. With WiFiSec Enforcement enabled, all non-guest wire-
less clients are required to use the strong security of IPSec. The VPN connection inherent in
WiFiSec terminates at the GroupVPN Policy, which you can configure on the VPN > Settings
page.
• If you have not selected WiFiSec Enforcement, you can select Require WiFiSec for Site-to-Site
VPN Tunnel Traversal to require WiFiSec security for all wireless connections through the WLAN
zone that are part of a site-to-site VPN.
• Click Trust WPA traffic to accept WPA as an allowable alternative to IPSec. The SonicWALL TZ
50 Wireless/TZ 150 Wireless/TZ 170 Wireless supports both WPA-PSK (Pre-shared key) and
WPA-EAP (Extensible Authentication Protocol using an external 802.1x/EAP capable RADIUS
server).
• WLAN IP Address: The IP address of the SonicWALL TZ 50 Wireless/TZ 150 Wireless/TZ 170
Wireless WLAN interface.
• WLAN Subnet Mask: The subnet of the SonicWALL TZ 50 Wireless/TZ 150 Wireless/TZ 170
Wireless WLAN interface.