Filter
Top Products
2 - 37
2 SYSTEM CONFIGURATION
The power supply module specifications (continued)
Performance specifications
Item
Q63P Q64P
Base loading position Power supply module loading slot
Applicable base unit Q33B, Q35B, Q38B, Q312B, Q65B, Q68B, Q612B
Input power supply
24VDC (+30%/-35%)
(15.6 to 31.2VDC)
100 to 120VAC/200 to 240VAC (+10%/-15%)
(85 to 132VAC/170 to 264VAC)
Input frequency —— 50/60Hz ±5%
Input voltage distortion factor —— 5% or less
Max. input apparent power 45W 160VA
Inrush current 100A 1ms or less 20A 8ms or less
5VDC 6A 8.5A
Rated output current
24VDC —— ——
5VDC 6.6A or more 9.9 to 14.4A Overcurrent
protection
(Note-1)
24VDC ——
5VDC 5.5 to 6.5V Overvoltage
protection
(Note-2)
24VDC ——
Efficiency 70% or more
Permissible instantaneous power off
time
(Note-3)
10ms or less(at 24VDC input) 20ms or less
Dielectric withstand voltage 500VAC across primary and 5VDC
Across inputs/LG and outputs/FG
2,830VAC rms/3 cycles
(Altitude : 2000m (6561.68ft.) )
Insulation resistance 10M or more by insulation resistance tester
Across inputs and outputs (LG and FG
separated), across inputs and LG/FG, across
outputs and LG/FG 10
or more by insulation
resistance tester(500VDC)
Noise immunity
• By noise simulator of 500Vp-p noise voltage,
1
µ
s noise width and 25 to 60Hz noise
frequency
• By noise simulator of 1,500Vp-p noise
voltage, 1
µ
s noise width and 25 to 60Hz noise
frequency
• Noise voltage IEC61000-4-4, 2kV
Operation indication LED indication (Lit at 5VDC output)
Fuse Built-in (Unchangeable by user)
Application
ERR contact (contact switched off (opened: normally closed contact) at an error stop of CPU),
for CPU module operating status output
Rated switching
voltage/current
24VDC, 0.5A
Minimum switching load 5VDC, 1mA
Response time OFF to ON: 10ms or less. ON to OFF: 12ms or less
Life time
Mechanical : 2 million times or more
Electrical : 100 thousand times at rated switching voltage/current or more
Surge suppressor None
Contact
output
section
Fuse None
Terminal screw size M3.5 × 7
Applicable wire size 0.75 to 2mm
2
Applicable crimping terminal RAV1.25 to 3.5, RAV2 to 3.5
Applicable tightening torque 0.59 to 0.78
N•m
Exterior dimensions[mm(inch)]
98(H) × 55.2(W) × 90(D)
(3.86(H) × 2.17(W) × 3.54(D) )
98(H) × 55.2(W) × 115(D)
(3.86(H) × 2.17(W) × 4.53(D) )
Mass [kg] 0.33 0.40