Filter
Top Products
2 - 95
2 SYSTEM CONFIGURATION
Correspondences between dno.s and axis select switches of servo amplifier
dno.
(Note)
SSCNET
SYSTEM
Servo amplifier's
rotary switch
dno.
(Note)
SSCNET
SYSTEM
Servo amplifier's
rotary switch
1 1 "0" 1 2 "0"
2 1 "1" 2 2 "1"
3 1 "2" 3 2 "2"
4 1 "3" 4 2 "3"
5 1 "4" 5 2 "4"
6 1 "5" 6 2 "5"
7 1 "6" 7 2 "6"
8 1 "7"
8 2 "7"
dno.
(Note)
SSCNET
SYSTEM
Servo amplifier's
rotary switch
dno.
(Note)
SSCNET
SYSTEM
Servo amplifier's
rotary switch
1 3 "0" 1 4 "0"
2 3 "1" 2 4 "1"
3 3 "2" 3 4 "2"
4 3 "3" 4 4 "3"
5 3 "4" 5 4 "4"
6 3 "5" 6 4 "5"
7 3 "6" 7 4 "6"
8 3 "7" 8 4 "7"
(Note) : The dno. is axis number of servo amplifier axis displayed in the system settings of
programming software. Axis No. is set relative to dno. in the system settings.
The Dividing unit (Q173DV) and the SSCNET cables (Q173J2B CBL M/
Q173HB
CBL M) between the Motion CPU and servo amplifiers divide signals
allocated in CN1 of the Q173CPU(N) into each of the four systems.
Corresponding between connector No. after division and SSCNET system No. is
shown below.
Correspondences between SSCNET SYSTEM No. and connector No. of CPU
SSCNET SYSTEM No. Connector No. of Dividing unit Connector No. of SSCNET cable
1 SSCNET CN1 1
2 SSCNET CN2 2
3 SSCNET CN3 3
4 SSCNET CN4 4
(Note) : SSCNET SYSTEM No. Q173CPU(N) : 4 systems / Q172CPU(N) : 1 system.