Filter
Top Products
4 - 5
4 INSTALLATION AND WIRING
4.1.3 Installation and removal of module
This section explains how to install and remove a power supply module, PLC CPU
module, Motion CPU module, Motion module, I/O module, intelligent function module
or another module to and from the base unit.
(1) Installation and removal of the module from Q3 B,Q6 B
The installation and removal procedure of the module from Q3 B/Q6 B base
unit are described below.
(a) Installation of the module to Q3
B and Q6 B
Module
Module
fixing hook
Base unit
Base unit
Module loading
lever
Completion
Insert the module fixing hook
into the module fixing hole of
the base unit.
Push the module in the
direction of arrow to install it
into the base unit.
Make sure that the module
is installed in the base unit
correctly.
Module
connector
Module fixing hole
Module fixing hole
Module fixing hook
POINTS
(1) Always insert the module fixing hook of the module into the module fixing hole.
Forcing the hook into the hole will damage the module connector and module.
(2) When using the modules in a place where there is large vibration or impact,
screw the module to the base unit.
Module fixing screw : M3
12 (purchase from the other supplier)