Mitsubishi Electronics Q172CPU9(N) Home Security System User Manual


 
4 - 7
4 INSTALLATION AND WIRING
4.2 Installation and Removal of Cable
4.2.1 SSCNET cable
(1) Precautions for handling the SSCNET cable
• Do not stamp the SSCNET cable.
• When laying the SSCNET cable, be sure to secure the minimum cable bend
radius of 30 mm(1.18 inch) or more.
If the minimum cable bend radius is less than 30 mm(1.18 inch), it may cause
malfunctions due to characteristic deterioration, wire breakage, etc.
• For installation or removal of the SSCNET cable, hold surely a tab of cable
connector.
CN2
Motion CPU
module
CN1
(2) Installation of the SSCNET cable
• For installation of the SSCNET cable to the Motion CPU, connect it to the
SSCNET connector CN1 or CN2 of Motion CPU while holding a tab of
SSCNET cable connector. Be sure to insert it until it clicks.
(3) Removal of the SSCNET cable
• For removal of the SSCNET cable, pull out it while holding a tab of SSCNET
cable connector after making sure that the fixing hook have been removed
completely.
POINT
Forcibly removal the SSCNET cable from the Motion CPU module will damage the
Motion CPU modules and SSCNET cables.