Filter
Top Products
329
Print Meter for 2746e and G-Series
oL
12/16/13 EPL Programming Guide 14245L-003
oL
Print Head Life Reminder Control
Description Use this command to customize the print head life reminder report. See the
URR command to check the settings and status.
Syntax oL[p
1
,p
2
,p
3]
Parameters This table identifies the parameters for this format:
Example •
oL40 ; Sets the threshold to 40km, frequency and message are default
oL,5 ; Sets the frequency to 5 labels, threshold and message are default
oL,,”Replace the print head”
; Sets the message to Replace the print head, threshold and
; frequency are default
Parameters Details
No parameters
Resets the parameters to their default values for print head life
reminder reporting.
p
1
= Reminder Threshold
Sets the distance to be printed before a reminder label
warning can be issued. Omitting or setting the value to 0will
reset it to the default value of 50 kilometers.
Default Value: 50 kilometers
Accepted Values: 1–255; 1 = 1 kilometer
p
2
= Frequency of
Reminder
Sets the number of labels to be printed prior to issuing
another reminder label.
Omitting the parameter will reset it to the default. The 0 value
causes the printer with the reminder enabled and in effect, to
report a Reminder Message at power-up, error recovery, after
a media out condition, a reset or after Cancel has been pressed
on the printer.
Default Value: 0 labels
Accepted Values: 1–255; 1 = 1 label printed
p
3
= Message “DATA” Default Value: PRINTHEAD LIFE EXCEEDED
Represents a fixed data field for a message of 39 characters or
less. The message “DATA” is bound by quotes. See the EPL2
programming ASCII Text (A) and the Character Set Selection
commands for details on printing text.