Filter
Top Products
157
EPL Commands
UP
12/16/13 EPL Programming Guide 14245L-003 Rev. A
UP
Codepage & Memory Inquiry/Print
Description This command will cause the printer to print and send the currently selected
codepage and memory status to the host through the RS-232 port.
This command also disables software flow control (XON/XOFF). Hardware flow control is
not disabled (DTR/CTS). To restart software flow control a reset (^@ command) or power
must be recycled.
See also the I, M, U, UI and UM commands.
Syntax UP
The printer will send information about the currently selected code page and memory
status back to the host followed by printing the current printer configuration. For an
example of the configuration printout, see the U command.
The format of data sent to the host is as follows:
UPp
1
,p
2
,p
3
,p
4
,p
5
,p
6
,p
7
,p
8
Parameters This table identifies the parameters for this format:
Parameters Details
p
1
Image buffer size in KBytes.
p
2
Form memory allocation size in KBytes.
p
3
Form memory free in KBytes.
p
4
Graphic memory allocation size in KBytes.
p
5
Graphic memory free in KBytes.
p
6
External font memory allocation size in KBytes.
p
7
External font memory free in KBytes.
p
8
Appends a response in the UI command data format. See the
UI command on page 154.
Example •
Up↵