Filter
Top Products
253
SGD Wireless Commands
ip.addr
12/16/13 EPL Programming Guide 14245L-003 Rev. A
ip.addr
Description This command allows you to get or set the printer’s IP address. For printer
support, see SGD Command Support on page 315.
Type getvar; setvar
This table identifies the commands for this format:
Important • For a set IP address to take affect, the IP protocol must be set to permanent and
the print server must be reset.
Note • For details on SGD command structure, see SGD Wireless Commands on page 247.
Commands Details
getvar
This command instructs the printer to respond with its current IP address.
Format: ! U1 getvar "ip.addr"
setvar
This command instructs the printer to change its current IP address upon
powering the printer on.
Format: ! U1 setvar "ip.addr" "value"
Va lues: any valid IP address
Default: "0.0.0.0"
Note • The setvar value of this command can be affected by the ip.dhcp.enable
command.
Example • This setvar example shows the value set to "10.14.4.235".
! U1 setvar "ip.addr" "10.14.4.235"
What the setvar value is set to is the getvar result. In this example, the getvar result is
"10.14.4.235".