SGD Wireless Commands
wlan.adhocchannel
266
14245L-003 Rev. A EPL Programming Guide 12/16/13
wlan.adhocchannel
Description This printer setting refers to specifying the wireless channel for adhoc channel.
For printer support, see SGD Command Support on page 315.
Type getvar; setvar
This table identifies the commands for this format:
Note • For details on SGD command structure, see Command Structure on page 250.
Commands Details
getvar
This command instructs the printer to respond with the wireless channel
for adhoc channel mode.
Format: ! U1 getvar "wlan.adhocchannel"
setvar
This command instructs the printer to set the wireless channel for adhoc
channel mode.
Format: ! U1 setvar "wlan.adhocchannel" "value"
Va lues: Decimal value between 1 and 16 inclusive
Default: "1"
Example • This setvar example shows the value set to "1".
! U1 setvar "wlan.adhocchannel" "1"
When the setvar value is set to "1", the getvar result is "1".