Filter
Top Products
SGD Command Support
Printer and Firmware Compatibility
316
14245L-003 EPL Programming Guide 12/16/13
Printer and Firmware Compatibility
Table 7 identifies the supported printer model and minumum firmware version for all SGD
commands. In order to set and get configurations, the SGD commands can be used through the
Ethernet, serial, parallel, and USB interfaces.
Note • The printer responds with the printer setting of "?" if the printer setting:
• does not exist
• has not been configured yet
Important • All the firmware versions noted in Table 7, refer to minimum firmware version
required.
Table 7 • SGD Command Syntax
SGD Commands
ZM400, ZM600 G-Series
appl.bootblock E53.15.x V61.15.xZ
V56.15.xZ
appl.name
E53.15.x V61.15.xZ
V56.15.xZ
card.inserted E53.15.x V61.15.xZ
V56.15.xZ
card.mac_addr E53.15.x V61.15.xZ
V56.15.xZ
cutter.clean_cutter V61.15.xZ
V56.15.xZ
device.languages E53.15.x V61.15.xZ
V56.15.xZ
device.pnp_option V61.15.xZ
V56.15.xZ
external_wired.ip.addr ** E53.15.x —
external_wired.ip.arp_interval
E53.15.x —
external_wired.ip.default_addr.enable
E53.15.x —
external_wired.ip.dhcp.cid_all
** E53.15.x —
external_wired.ip.dhcp.cid_enable
** E53.15.x —
external_wired.ip.dhcp.cid_prefix
** E53.15.x —
external_wired.ip.dhcp.cid_suffix
** E53.15.x —
external_wired.ip.dhcp.cid_type
** E53.15.x —
external_wired.ip.gateway
E53.15.x —
external_wired.ip.netmask
E53.15.x —
* On these printers with ZebraNet™ 10/100 Internal Print Server.
** On these printers with ZebraNet™ 10/100 External Print Server, firmware version 1.1.5