Filter
Top Products
SGD Wireless Commands
wlan.ip.arp_interval
272
14245L-003 Rev. A EPL Programming Guide 12/16/13
wlan.ip.arp_interval
Description This print server setting allows you to specify the ARP (Address Resolution
Protocol) interval or the ARP cache time out for the wireless print server. For printer support,
see SGD Command Support on page 315.
Type getvar; setvar
This table identifies the commands for this format:
Note • For details on SGD command structure, see Command Structure on page 250.
Commands Details
getvar
This command instructs the printer to respond with the ARP interval or the
ARP cache time out value (in seconds) for the wireless print server.
Format: ! U1 getvar "wlan.ip.arp_interval"
setvar
This command instructs the printer to respond with the ARP interval or the
ARP cache time out value for the wireless print server.
Format: ! U1 setvar "wlan.ip.arp_interval" "value"
Va lues: 0 to 30 seconds
Default: "0"
Example • This setvar example shows the value set to "0".
! U1 setvar "wlan.ip.arp_interval" "0"
What the setvar value is set to is the getvar result. In this example, the getvar result is
"0".