Filter
Top Products
305
SGD Wireless Commands
wlan.tx_rate
12/16/13 EPL Programming Guide 14245L-003 Rev. A
wlan.tx_rate
Description This printer setting refers to specifying the wireless transmit rate. For printer
support, see SGD Command Support on page 315.
Type getvar; setvar
This table identifies the commands for this format:
Note • For details on SGD command structure, see Command Structure on page 250.
Commands Details
getvar
This command instructs the printer to respond with the wireless transmit
rate.
Format: ! U1 getvar "wlan.tx_rate"
setvar
This command instructs the printer to set the wireless transmit rate.
Format: ! U1 setvar "wlan.tx_rate" "value"
Va lues: 1, 2, 5.5, 11, all
Default: "all"
Example • This setvar example shows the value set to "all".
! U1 setvar "wlan.tx_rate" "all"
When the setvar value is set to "all", the getvar result is "all".