Filter
Top Products
SGD Wireless Commands
wlan.kerberos.password
288
14245L-003 Rev. A EPL Programming Guide 12/16/13
wlan.kerberos.password
Description This printer setting refers to the Kerberos password. The password must
correspond to a user profile established on the Kerberos KDC server in use. For printer
support, see SGD Command Support on page 315.
Type getvar; setvar
This table identifies the commands for this format:
Note • For details on SGD command structure, see Command Structure on page 250.
Commands Details
getvar
This command instructs the printer to respond with the current Kerberos
password.
Format: ! U1 getvar "wlan.kerberos.password"
For protection a single "*" prints.
setvar
This command instructs the printer to set the Kerberos password.
Format: ! U1 setvar "wlan.kerberos.password" "value"
Va lues: 0-32 alphanumeric characters
Default: "password"
Example • This setvar example shows the value set to "password".
! U1 setvar "wlan.kerberos.password" "password"
When the setvar value is set to "password", the getvar result is "*".