Filter
Top Products
SGD Wireless Commands
wlan.ip.protocol
282
14245L-003 Rev. A EPL Programming Guide 12/16/13
wlan.ip.protocol
Description This command configures the IP addressing method used by the wireless print
server. For printer support, see SGD Command Support on page 315.
Type getvar; setvar
This table identifies the command for this format:
Note • For details on SGD command structure, see Command Structure on page 250.
Commands Details
getvar
This command returns the value of the currently selected IP protocol used
by the wireless print server.
Format: ! U1 getvar "wlan.ip.protocol"
setvar
This command instructs the printer to configure the IP addressing method
used by the wireless print server.
Format:
! U1 setvar "wlan.ip.protocol" "value"
Va lues:
"bootp" = uses the standard bootp addressing method to obtain an
IP address and configuration
"dhcp" = uses the standard dhcp addressing method to obtain an IP
address and configuration for a server specified period of time
"rarp" = uses the standard rarp addressing method to obtain an IP
address
"glean" = uses the IP address from a PING packet that is sent to its
hardware address (unicast address)
“permanent” = uses static values assigned through other
commands
"all" = tries all of the dynamic addressing methods, not permanent,
to obtain an IP address
Default: "all"
Example • In this example, the setvar result is the current programming language that the
printer is using.
! U1 setvar "wlan.ip.protocol" "bootp"
What the setvar value is set to is the getvar result. In this example, the getvar result is
"bootp".