Filter
Top Products
SGD Wired Commands
internal_wired.ip.gateway
240
14245L-003 Rev. A EPL Programming Guide 12/16/13
internal_wired.ip.gateway
Description This command instructs the printer to change the internal wired print servers
gateway address. For printer support, see SGD Command Support on page 315.
Type getvar; setvar
This table identifies the commands for this format:
Important • This setting refers to the gateway address. A set value is ignored if the IP
protocol is not set to permanent.
Note • For details on SGD command structure, see Command Structure on page 216.
Commands Details
getvar
This command instructs the printer to respond with the internal wired
printer servers gateway address.
Format: ! U1 getvar "internal_wired.ip.gateway"
setvar
This command instructs the printer to change the internal wired printer
servers gateway address.
Format:
! U1 setvar "internal_wired.ip.gateway" "value"
Va lues: Any valid gateway address
Default: "0.0.0.0"
Example • This setvar example shows the value set to "10.3.5.1".
! U1 setvar "internal_wired.ip.gateway" "10.3.5.1"
When the setvar value is set to "10.3.5.1", the getvar result is "10.3.5.1".