Filter
Top Products
129
EPL Commands
oR
12/16/13 EPL Programming Guide 14245L-003 Rev. A
oR
Character Substitution (Euro)
Description This command allows the advanced programmer to substitute the Euro
currency character for any ASCII character in printer resident font numbers 1-4.
The second function this command supports is the zero character style toggling between a
plain zero character and a zero with a slash.
Character substitution settings are stored in the printers non-volatile 'flash' memory. The
original character can be restored by sending the oR command without a parameter.
Syntax oR[p
1
,p
2
]
Parameters This table identifies the parameters for this format:
Parameters Details
p
1
= E
If the p
2
parameter is not provided, then the Euro character
will map to code page position 213 decimal (D5 hexadecimal)
for all code pages.
p
1
= 0 (zero)
Toggles the zero character:
slash — no slash (out of box default)
p
2
= Decimal number Accepted Values: 0 to 255
The active code page’s ASCII character map position to be
replaced by the Euro character. The Euro character will be
active in this map position for all code pages. See the I
command for details on code page selection.
None = No parameters
(p
1
/p
2
)
No Parameters (p
1
/p
2
) resets to all code pages to original
default character mapping.
Optionally, to reapply normal character operations, issue a o
(111 dec. or 6F hex.) command. See page 123 for important
details on the effects of using this command.
Note • The Euro character is not supported in Font 5 character set.