Zebra Technologies 14245L-003 Pet Fence User Manual


  Open as PDF
of 876
 
27
Introduction
Placing Elements in the Print Image
12/16/13 EPL Programming Guide 14245L-003
Placing Elements in the Print Image
Image elements are located in the image print buffer on an X-Y grid expressed in dots. The X
value represents the width and the Y value represents the height of the grid.
The point of origin (the starting point) for a non-rotated object is the upper left corner. As an
object rotates, the point of origin rotates with the object.
These image buffer properties are depicted graphically in the following illustration.
Figure 2 • Sample Format
The minimum non-printing margin on all edges of the label is 1 mm. Printing closer than 1
mm to the top or bottom edge of the label may cause the printer to advance unwanted labels or
cause the printer to go into error condition.
2
EPUT
YBYJT
ZBYJT
%JSFDUJPO0G'FFE

7H[W
7H[W
7H[W
1PJOUPG
0SJHJOGPS
5FYU0CKFDU
1PJOUPG
0SJHJOGPS
5FYU0CKFDU
3PUBUFE¡
1PJOUPG
0SJHJOGPS
5FYU0CKFDU
3PUBUFE¡
1PJOUPG
0SJHJOGPS
#BS$PEF0CKFDU
REPUT
 previous next