Filter
Top Products
265
SGD Wireless Commands
wlan.adhocautomode
12/16/13 EPL Programming Guide 14245L-003 Rev. A
wlan.adhocautomode
Description This printer setting refers to enabling or disabling the adhoc auto mode. For
printer support, see SGD Command Support on page 315.
Type getvar; setvar
This table identifies the commands for this format:
Note • For details on SGD command structure, see Command Structure on page 250.
Commands Details
getvar
This command instructs the printer to respond with the adhoc auto mode
status.
Format: ! U1 getvar "wlan.adhocautomode"
setvar
This command instructs the printer to set the adhoc auto mode.
Format: ! U1 setvar "wlan.adhocautomode" "value"
Va lues:
"on" = adhoc auto mode enabled
"off" = adhoc auto mode disabled
Default: "off"
Example • This setvar example shows the value set to "on".
! U1 setvar "wlan.adhocautomode" "on"
When the setvar value is set to "on", the getvar result is "on".