Filter
Top Products
SGD Wireless Commands
wlan.wpa.psk
314
14245L-003 Rev. A EPL Programming Guide 12/16/13
wlan.wpa.psk
Description This printer setting specifies the pre-shared key (PSK) value to use when the
WPA authentication is set to PSK. For printer support, see SGD Command Support
on page 315..
Type getvar; setvar
This table identifies the commands for this format:
Note • For details on SGD command structure, see Command Structure on page 250.
Commands Details
getvar
This command instructs the printer to respond with the pre-shared key.
Format: ! U1 getvar "wlan.wpa.psk"
For protection a single "*" prints.
setvar
This command instructs the printer to set the pre-shared key.
Format: ! U1 setvar "wlan.wpa.psk" "value"
Va lues: 64 hexadecimal digits
Default: 64 zeros (00000000...)
Example • This setvar example shows the value set to "00000000...".
! U1 setvar "wlan.wpa.psk" "00000000..."
When the setvar value is set to "00000000...", the getvar result is "*".