Filter
Top Products
233
SGD Wired Commands
internal_wired.ip.arp_interval
12/16/13 EPL Programming Guide 14245L-003 Rev. A
internal_wired.ip.arp_interval
Description This print server setting allows you to specify the ARP (Address Resolution
Protocol) interval or the ARP cache time out for the internal wired print server. For printer
support, see SGD Command Support on page 315.
Type getvar; setvar
This table identifies the commands for this format:
Note • For details on SGD command structure, see Command Structure on page 216.
Commands Details
getvar
This command instructs the printer to respond with the ARP interval or the
ARP cache time out value for the internal wired print server.
Format:
! U1 getvar "internal_wired.ip.arp_interval"
setvar
This command instructs the printer to change the ARP interval or the ARP
cache time out for the internal wired print server.
Format:
! U1 setvar "internal_wired.ip.arp_interval" "
value
"
Va lues: 0 - 30
Default: "0"
Example • This setvar example shows the value set to "0".
! U1 setvar "internal_wired.ip.arp_interval" "0"
What the setvar value is set to is the getvar result. In this example, the getvar result is
"0".