Filter
Top Products
239
SGD Wired Commands
internal_wired.ip.dhcp.cid_type
12/16/13 EPL Programming Guide 14245L-003 Rev. A
internal_wired.ip.dhcp.cid_type
Description This printer setting defines the type of client identifier (DHCP option 61) that
will be sent if DHCP is enabled on the internal wired print server. A value of "1" means the
type of "Ethernet" and the printer’s MAC address will be used.A value of "0" or "2" means
the client identifier sent will be "internal_wired.ip.dhcp.cid_prefix"
concatenated with "internal_wired.ip.dhcp.cid_suffix". For printer support,
see SGD Command Support on page 315.
Type getvar; setvar
This table identifies the commands for this format:
Note • For details on SGD command structure, see Command Structure on page 216.
Commands Details
getvar
This command instructs the printer to respond with the client identifier
type for the internal wired print server.
Format:
! U1 getvar "internal_wired.ip.dhcp.cid_type"
setvar
This command instructs the printer to enable "synthetic" Client Identifier
for the internal wired print server.
Format:
! U1 setvar "internal_wired.ip.dhcp.cid_type"
"value"
Va lues:
"0" = ASCII string
"1" = wired print server’s MAC address
"2" = HEX value
Default Value: "1"
Example • This setvar example shows the value set to "1".
! U1 setvar "internal_wired.ip.dhcp.cid_type" "1"
What the setvar value is set to is the getvar result. In this example, the getvar result is
"1".