Filter
Top Products
225
SGD Wired Commands
external_wired.ip.gateway
12/16/13 EPL Programming Guide 14245L-003 Rev. A
external_wired.ip.gateway
Description This command instructs the printer to change the external wired print server’s
gateway address. For printer support, see SGD Command Support on page 315.
Type getvar; setvar
This table identifies the commands for this format:
Important • This setting refers to the gateway address. A set value is ignored if the IP
protocol is not set to permanent.
Note • For details on SGD command structure, see Command Structure on page 216.
Commands Details
getvar
This command instructs the printer to respond with the external wired
printer server’s gateway address.
Format: ! U1 getvar "external_wired.ip.gateway"
setvar
This command instructs the printer to change the external wired printer
server’s gateway address.
Format:
! U1 setvar "external_wired.ip.gateway" "value"
Va lues: Any valid gateway address
Default: "0.0.0.0"
Example • This setvar example shows the value set to "10.3.5.1".
! U1 setvar "external_wired.ip.gateway" "10.3.5.1"
When the setvar value is set to "10.3.5.1", the getvar result is "10.3.5.1".