Filter
Top Products
293
SGD Wireless Commands
wlan.password
12/16/13 EPL Programming Guide 14245L-003 Rev. A
wlan.password
Description This printer setting refers to the generic password that is used by the wireless
securities that need a password. For printer support, see SGD Command Support on page 315.
Type getvar; setvar
This table identifies the commands for this format:
Important • Kerberos has its own password field
Note • For details on SGD command structure, see Command Structure on page 250.
Commands Details
getvar
This command instructs the printer to respond with a generic password for
wireless securities.
Format: ! U1 getvar "wlan.password"
For protection a single "*" prints.
setvar
This command instructs the printer to set a generic password for the
wireless securities that need a password.
Format: ! U1 setvar "wlan.password" "value"
Va lues: A maximum of 32 alphanumeric characters.
Default: "password"
Example • This setvar example shows the value set to "password".
! U1 setvar "wlan.password" "password"
When the setvar value is set to "password", the getvar result is "*".