Filter
Top Products
SGD Wireless Commands
wlan.keep_alive.timeout
286
14245L-003 Rev. A EPL Programming Guide 12/16/13
wlan.keep_alive.timeout
Description This printer setting manages the interval at which the LSAP (link service
access point) packet is sent. For printer support, see SGD Command Support on page 315.
Type getvar; setvar
This table identifies the commands for this format:
Note • For details on SGD command structure, see Command Structure on page 250.
Commands Details
getvar
This command instructs the printer to respond with the
wlan.keep_alive.timeout interval value.
Format: ! U1 getvar "wlan.keep_alive.timeout"
setvar
This command instructs the printer to configure the frequency at which the
printer sends the wlan.keep_alive packet.
Format: ! U1 setvar "wlan.keep_alive.timeout" "value"
Va lues: 5 to 300 seconds
Default: "15"
Example • This setvar example shows the value set to "15".
! U1 setvar "wlan.keep_alive.timeout" "15"
When the setvar value is set to "15", the getvar result is "15".