Filter
Top Products
SGD Wireless Commands
ip.arp_interval
254
14245L-003 Rev. A EPL Programming Guide 12/16/13
ip.arp_interval
Description This printer setting allows you to specify the ARP (Address Resolution
Protocol) interval or the ARP cache time out. For printer support, see SGD Command Support
on page 315.
Type getvar; setvar
This table identifies the commands for this format:
Note • For details on SGD command structure, see Command Structure on page 250.
Commands Details
getvar
This command instructs the printer to respond with the ARP interval or the
ARP cache time out value in seconds.
Format: ! U1 getvar "ip.arp_interval"
setvar
This command instructs the printer to change the ARP interval or the ARP
cache time out.
Format: ! U1 setvar "ip.arp_interval" "value"
Va lues: 0 - 30
Default: "0"
Example • This setvar example shows the value set to "0".
! U1 setvar "ip.arp_interval" "0"
What the setvar value is set to is the getvar result. In this example, the getvar result is
"0".